TEXTILES – DETERMINATION OF THICKNESS OF TEXTILES AND TEXTILE PRODUCTS (ISO 5084:1996, IDT)
MS ISO 5084:2003 (CONFIRMED:2015)Status : 1st Confirmation
Format : PDF
This Malaysian Standard specifies a method for the determination of the thickness of textiles and textile products when under a specified pressure. It is not applicable to textile floor coverings, non ....Read more
INLET AIR CLEANING EQUIPMENT FOR INTERNAL COMBUSTION ENGINES AND COMPRESSORS - PERFORMANCE TESTING (ISO 5011:2000, IDT)
MS ISO 5011:2005Status : Original
Format : PDF
This Malaysian Standard establishes and specifies uniform test procedures, conditions, equipment, and a performance report to permit the direct laboratory performance comparison of air cleaners.
....Read more
Cold-reduced carbon steel sheet for vitreous enamelling (ISO 5001:2012, IDT)
MS ISO 5001:2014 (CONFIRMED:2025)Status : 1st Confirmation
Format : PDF
This Malaysian Standard applies to cold-reduced carbon steel sheet of commercial and drawing qualities for vitreous enamelling, where the surface of the sheet and chemical composition of the base meta ....Read more
Cold-reduced carbon steel sheet of structural quality
MS ISO 4997:2015Status : Original
Format : PDF
This Malaysian Standard applies to cold-reduced carbon steel sheet of structural quality in grades CR220, CR250, CR320, and CH550, usually without the use of microalloying elements. The product is int ....Read more
STEEL CASTINGS - GENERAL TECHNICAL DELIVERY REQUIREMENTS (ISO 4990:2003, IDT)
MS ISO 4990:2005Status : Original
Format : PDF
This Malaysian Standard specifies the general technical delivery requirements for the supply of steel, nickel and cobalt alloy castings, including the requirements for the selection and preparation of ....Read more
Cold-reduced carbon steel strip with a mass fraction of carbon over 0.25 % (ISO 4960:2007, IDT)
MS ISO 4960:2014Status : Original
Format : PDF
This Malaysian Standard applies to cold-reduced carbon steel strip with a mass fraction of carbon over 0.25 % made from the steels. It is commonly produced in thicknesses of 6 mm and under, and in wid ....Read more
STEEL NAMES BASED ON LETTER SYMBOLS (ISO/TS 4949:2003, IDT)
MS ISO/TS 4949:2007Status : Original
Format : PDF
This Malaysian Standard sets out rules for designation of internationally standardized steel grades by means of symbolic letters and numbers to express application and principal characteristics (e.g. ....Read more
STEELS – CLASSIFICATION – PART 1: CLASSIFICATION OF STEELS INTO UNALLOYED AND ALLOY STEELS BASED ON CHEMICAL COMPOSITION (ISO 4948-1:1982, IDT)
MS ISO 4948-1:2007Status : Original
Format : PDF
This Malaysian Standard lays down a classification of steels into unalloyed and alloy steels based on chemical composition. Part 2 lays down the classification of unalloyed and alloy steels according ....Read more
STEELS - CLASSIFICATION - PART 2: CLASSIFICATION OF UNALLOYED AND ALLOY STEELS ACCORDING TO MAIN QUALITY CLASSES AND MAIN PROPERTY OR APPLICATION CHARACTERISTICS (ISO 4948-2:1981, IDT)
MS ISO 4948-2:2007Status : Original
Format : PDF
This Malaysian Standard lays down a classification of unalloyed and alloy steels according to main quality classes and main property or application characteristics.
Part 1 lays down the classi
....Read more
Brake cylinders using a non-petroleum base hydraulic brake fluid (Service temperature 150 °C max.) (ISO 4930:2006, IDT)
MS ISO 4930:2008 (CONFIRMED:2013)Status : Original
Format : PDF
This Malaysian Standard specifies the performance test methods and requirements for elastomeric seals used in road vehicle disc brake cylinders.
It is applicable to solid section type seals (s
....Read more