• :  
BM ENG
  • Subscription
  • MS Catalogue
  • MS Pack
  • Purchase History
  • Cart
  • Hi
    !
    • My Profile
    • Portal
    • Log Out

Modal title

Widget settings form goes here

Search Malaysian StandardSearch Malaysian Standard (MS) hehe (MS)
 Advanced Search Search

Test method for the analysis of extractable proteins in natural rubber products
MS 1392:1998 (CONFIRMED:2018)
Status : 1st Confirmation
Format : PDF

This Malaysian Standard specifies a method of measuring the accelerated storage hardening of raw natural rubber using the Wallace plastimeter.

RM 15.00

Document will be sent via email



 Add To Cart
RUBBER - DETERMINATION OF METAL CONTENT BY ATOMIC ABSORPTION SPECTROMETRY - PART 7: DETERMINATION OF CALCIUM CONTENT
MS 1449: PART 7:2016
Status : Original
Format : PDF

This part of Malaysian Standard specifies an atomic absorption spectrometric method for the determination of the calcium content of rubbers.

RM 15.00

Document will be sent via email



 Add To Cart
Rubber and rubber products - Determination of polybrominated diphenyl ethers (PBDEs) by gas chromatography-mass spectrometry (GC-MS)
MS 2621:2016
Status : Original
Format : PDF

This Malaysian Standard specifies a test method for the determination of polybrominated diphenyl ethers (PBDEs), that is applicable to monobrominated diphenyl ether to decabrominated diphenyl ether by ....Read more gas chromatography-mass spectrometry (GC-MS) in rubber, vulcanised rubber, rubber products and recycled rubber which are extracted by toluene.
This test method should be used under controlled laboratory conditions to detect and quantify the level of monobrominated to nonabrominated above 0.5 μg/g and decabrominated above 5 μg/g found in rubber containing products. It should not be used to describe, appraise or assess the hazard or risk of these rubber containing materials or products under actual usage conditions. Close

RM 30.00

Document will be sent via email



 Add To Cart
Natural rubber (NR) latex foams - Specification
MS 2622:2016
Status : Original
Format : PDF

This Malaysian Standard specifies the requirements and methods of test for latex foams made of natural rubber latex intended for bedding and general use.

RM 15.00

Document will be sent via email



 Add To Cart
Malathion – Specification and test methods
MS 2631:2017 (CONFIRMED:2024)
Status : 1st Confirmation
Format : PDF

This Malaysian Standard specifies requirements and test methods for malathion
technical material, dustable powder, ultra-low volume liquid, emulsifiable concentrate
and emulsion, oil in ....Read more water. Close

RM 75.00

Document will be sent via email



 Add To Cart
Water quality - Sampling - Part 8: Guidance on the sampling of wet deposition (ISO 5667-8:1993, MOD)
MS ISO 5667-8:2017 (CONFIRMED:2025)
Status : 1st Confirmation
Format : PDF

This Malaysian Standard was developed by the Working Group on Sampling (Water Quality) under the authority of the Industry Standards Committee on Chemicals and Materials.
This Malaysian Standar ....Read more d is a modified adoption of ISO 5667-8:1993, Water Quality – Sampling – Part 8: Guidance on the sampling of wet deposition, published by the International Organization for Standardization (ISO) Close

RM 30.00

Document will be sent via email



 Add To Cart
Water quality – Sampling – Part 1: Guidance on the design of sampling programmes and sampling techniques (ISO 5667-1:2006, IDT)
MS ISO 5667-1:2016 (CONFIRMED:2025)
Status : 1st Confirmation
Format : PDF

Working Group Committee on Sampling (Water Quality) under the authority of the Industry Standards Committee on Chemical and Materials. This Malaysian Standard is identical with ISO 5667-1:2006, Water ....Read more quality ‒ Sampling ‒ Part 1: Guidance on the design of sampling programmes and sampling techniques, published by the International Organization for Standardization (ISO). However, for the purposes of this Malaysian Standard, the following apply:

a)in the source text, "this International Standard" should read "this Malaysian Standard";
b)the comma which is used as a decimal sign (if any), to read as a point; and
c)reference to International Standards should be replaced by corresponding MalaysianStandards as follows:
Referenced International Standards
Corresponding Malaysian Standards
ISO 6107-1, Water quality – Vocabulary – Part 1
MS ISO 6107-1, Water quality – Vocabulary
–Part 1
ISO 6107-2, Water quality – Vocabulary – Part 2
MS ISO 6107-2, Water quality–Vocabulary – Part 2
This Malaysian Standard cancels and replaces MS 1850: PART 1:2006 and MS 1850: PART 2:2005.
Compliance with a Malaysian Standard does not of itself confer immunity from legal obligations. Close

RM 60.00

Document will be sent via email



 Add To Cart
Surface active agents and detergents - Determination water content - Karl Fischer methods (First revision) (ISO 4317:2011, IDT)
MS ISO 4317:2017 (CONFIRMED:2025)
Status : 1st Confirmation
Format : PDF

This adoption of the ISO Standard as a Malaysian Standard was recommended by the Technical Committee on Soaps and Detergents under the authority of the Industry Standards Committee on Chemical and Mat ....Read more erials.

This Malaysian Standard is identical with ISO 4317:2011, Surface active agents and Detergents – Determination water content – Karl Fischer methods, published by the International Organization for Standardization (ISO). Close

RM 30.00

Document will be sent via email



 Add To Cart
WASHING POWDERS - DETERMINATION OF TOTAL PHOSPHORUS (V) OXIDE CONTENT - QUINOLINE PHOSPHOMOLYBDATE GRAVIMETRIC METHOD (ISO 4313:1976, IDT)
MS ISO 4313:2010 (CONFIRMED:2025)
Status : 2nd Confirmation
Format : PDF

The adoption of the ISO Standard as a Malaysian Standard was recommended by the
Technical Committee on Soap and Detergent under the authority of the Industry Standards Committee on Chemicals an ....Read more d Materials.
This Malaysian Standard is identical with ISO 4313:1976, Washing powders - Determination of total phosphorus(V) oxide content - Quinoline phosphomolybdate gravimetric method, published by the International Organization for Standardization (ISO). However, for the purposes of this Malaysian Standard, the following apply:
a) in the source text, "this International Standard" should read "this Malaysian Standard";
b) the comma which is used as a decimal sign (if any), to read as a point; and
c) reference to International Standards should be replaced by corresponding Malaysian
Standards as follows:
Referenced International Standards Corresponding Malaysian Standards
ISO 607:1980, Surface active agents and detergents - Method of sample division
MS ISO 607:2004, Surface active agents and detergents - Method of sample division
Compliance with a Malaysian Standard does not of itself confer immunity from legal
obligations. Close

RM 15.00

Document will be sent via email



 Add To Cart
Surface active agents - Detergents - Determination of cationic-active matter content - Part 2: Cationic-active matter of low molecular mass (between 200 and 500) (First revision) (ISO 2871-2:2010, IDT)
MS ISO 2871-2:2017 (CONFIRMED:2025)
Status : 1st Confirmation
Format : PDF

This adoption of the ISO Standard as a Malaysian Standard was recommended by the
Technical Committee on Soaps and Detergents under the authority of the Industry Standards Committee on Chemical ....Read more and Materials.

This Malaysian Standard is identical with ISO 2871-2:2010, Surface active agents –
detergents – determination of cationic-active matter content – Part 2: cationic-active matter of low molecular mass (between 200 and 500), published by the International Organization for Standardization (ISO). Close

RM 15.00

Document will be sent via email



 Add To Cart
  • ‹
  • 1
  • 2
  • ...
  • 571
  • 572
  • 573
  • 574
  • 575
  • 576
  • 577
  • ...
  • 585
  • 586
  • ›