MS Preview
MS ISO 60:2004 (CONFIRMED:2012)
Plastics - Determination of apparent density
of material that can be poured from a
specified funnel
(ISO 60:1977, IDT)
This Malaysian Standard specifies a method of determining the apparent density, i.e. the mass per unit of volume, of loose material (powder or granular material) that tan be poured from a funnel of specified design.
NOTE - For a method of determining the apparent density of loose moulding material that cannot be poured from a specified funnel.
When the method is applied to relatively coarse materials, rather variable results may be obtained, owing to the error introduced when a straightedge blade is drawn across the top of the cylinder.
A knowledge of apparent density is of limited value in estimating the relative fluffiness or bulk of moulding materials, unless their densities in the moulded condition are approximately the same.
1st Confirmation
• (none) / (none) / (none)
PDF
08/07/2019
10
NSC 10 - Plastics and Plastic Products
83.080.01
15.00