• :  
BM ENG
  • Subscription
  • MS Catalogue
  • MS Pack
  • Purchase History
  • Cart
  • Hi
    !
    • My Profile
    • Portal
    • Log Out

Modal title

Widget settings form goes here

Search Malaysian Standard (MS)
 Advanced Search Search

Adventure tourism – Safety management systems – Requirements (ISO 21101:2014, IDT) (Published by Standards malaysia in 2022)
MS ISO 21101:2014
Status : Original
Format : PDF

This International Standard outlines the requirements of a safety management system for adventure tourism activity providers.

A provider can use this International Standard for the foll ....Read more owing:

a) to enhance safety performance;
b) to meet expectations for participant and staff safety;
c) to demonstrate safe practice;
d) to support compliance with applicable legal requirements.

This International Standard can be used by all types and sizes of providers, operating in different geographic, cultural and social environments. Close

RM 45.00

Document will be sent via email



 Add To Cart
Boxes and Enclosures for Electrical Accessories for Household and Similar Fixed Electrical Installations – Part 24: Particular Requirements for Enclosures for Housing Protective Devices and Other Power Dissipating Electrical Equipment (First Revision) (IEC 60670-24:2011,IDT)(Published by Standards malaysia in 2022)
MS IEC 60670-24:2011
Status : 1st Revision
Format : PDF

Replacement:

This part of IEC 60670 applies to enclosures and parts of them for housing protective devices and other power dissipating electrical equipment intended to be used with a ra ....Read more ted voltage not exceeding 400 V and a total incoming load current not exceeding 125 A for household and similar fixed electrical installations.

These enclosures are intended to be installed where unskilled persons have access. They are intended to be integrated with electrical equipment on site by skilled persons (installers).

They are intended to be installed where the prospective short circuit current does not exceed 10 kA unless they are protected by current limiting protective devices with a cut-off current not exceeding 17 kA.

Enclosures complying with this standard are suitable for use, after installation, at ambient temperature not normally exceeding 25 °C, but occasionally reaching 35 °C over 24 h, max. 40 °C and min. –5 °C.

An enclosure which is an integral part of an electrical accessory and provides protection against external influences (e.g. mechanical impacts, ingress of solid objects or of water), is covered by the relevant standard for such an accessory.

This standard does not apply to a low-voltage switchgear and controlgear assembly (ASSEMBLY) as defined in the IEC 60439 or IEC 61439 series of standards nor to a main entrance panel which may or may not be part of the distribution board.

NOTE 1 A main entrance panel is a set composed by a panel or an enclosure equipped with a meter and/or the main incoming device. Main entrance panels comply with their appropriate standards or the requirements of the local supplier if any.

NOTE 2 In the following country this standard cannot be used in installations with a 230 V single phase supply rated up to 100 A that is under the control of ordinary persons. Integration of mechanical and electrical devices into an enclosure must be verified by compliance with IEC 60439-3 [British standard EN 60439-3]: UK.

NOTE 3 In the following country this standard can only be used for GP enclosures with the instructions according to Annex A. For the other types of enclosures the integration of mechanical and electrical devices into an enclosure is verified by compliance with DS EN 60439-3: DK. Close

RM 60.00

Document will be sent via email



 Add To Cart
Boxes and Enclosures for Electrical Accessories for Household and Similar Fixed Electrical Installations - Part 23: Particular Requirements for Floor Boxes and Enclosures (First Revision) (IEC 60670-23:2006+AMD1:2016, IDT) (Published by Standards malaysia in 2022)
MS IEC 60670-23:2016
Status : 1st Revision
Format : PDF

This clause of Part 1 is applicable except as follows:

Addition after the fourth paragraph:

This standard applies to boxes and enclosures Flush floor boxes and flush floo ....Read more r enclosures are intended to protect accessories against a load up to and including 1 000 N.

NOTE Outdoor requirements are under consideration Close

RM 30.00

Document will be sent via email



 Add To Cart
Boxes and Electrical Installations - Part 22: Particular Accessories for Household and Similar Fixed Boxes and Enclosures for Electrical MS IEC 60670-22:2015 Enclosures (First Revision) (IEC 60670-22:2003+AMD1:2015, IDT) (Published by Standards malaysia in 2022)
MS IEC 60670-22:2015
Status : 1st Revision
Format : PDF

This clause of Part 1 applies with the following addition:

Add after the fourth paragraph:

This standard applies to connecting boxes for junction(s) and/or tapping(s).
....Read more />
NOTE Unless otherwise stated, throughout the document the term “boxes” also applies to “enclosures”. Close

RM 45.00

Document will be sent via email



 Add To Cart
Boxes and Enclosures for Electrical Accessories for Household and Similar Fixed Electrical Installations-Part 21: Particular Requirementsfor Boxes and Enclosures with Provision for Suspension Means (First Revision) (IEC 60670-21:2004+AMD1:2016, IDT) (Published by Standards malaysia in2022)
MS IEC 60670-21:2016
Status : 1st Revision
Format : PDF

This clause of Part 1 is applicable with the following modification:

Addition after the fourth paragraph:

This standard applies to boxes and enclosures with provision for ....Read more suspension means. Close

RM 30.00

Document will be sent via email



 Add To Cart
Boxes and Enclosures for Electrical Accessories for Household and Similar Fixed Electrical Installations – Part 1: General Requirements (First Revision) (IEC 60670-1:2015, IDT) (Published by Standards malaysia in 2021)
MS IEC 60670-1:2015
Status : 1st Revision
Format : PDF

This part of IEC 60670 applies to boxes, enclosures and parts of enclosures (hereafter called “boxes” and “enclosures”) for electrical accessories with a rated voltage not exceeding 1 000 V a. ....Read more c. and 1 500 V d.c. intended for household or similar fixed electrical installations, either indoors or outdoors.

Boxes and enclosures complying with this standard are suitable for use at ambient temperatures not normally exceeding +40 °C, but their average over a period of 24 h does not exceed +35 °C, with a lower limit of the ambient air temperature of −5 °C.

During the installation the temperature may be outside the above temperature range according to the classification of the boxes and the enclosures.

This International Standard is intended to apply to boxes and enclosures for electrical accessories within the scope of IEC technical committee 23.

This standard may be used as a reference document for other IEC technical committees and subcommittees.

A box or an enclosure which is an integral part of an electrical accessory and provides protection for that accessory against external influences (for example mechanical impact, ingress of solid objects or water, etc.) is covered by the relevant standard for such an accessory.

This standard does not apply to
– ceiling roses;
– luminaire supporting couplers;
– boxes, enclosures and parts of enclosures specifically designed to be used for cable trunking and ducting systems complying with IEC 61084 and which are not intended to be installed outside of these systems. Close

RM 120.00

Document will be sent via email



 Add To Cart
Degrees of Protection provided by Enclosures (IP Code) (Second Revision) (IEC 60529: 1989+A1:1999+A2:2013, IDT) (Published by Standards malaysia in 2022)
MS IEC 60529:2013
Status : 2nd Revision
Format : PDF

This standard applies to the classification of degrees of protection provided by enclosures for electrical equipment with a rated voltage not exceeding 72,5 kV.

RM 105.00

Document will be sent via email



 Add To Cart
Safety of escalators and moving walks – Part 2: Rules for the improvement of safety of existing escalators and moving walks
MS 1918-2:2019, AMD. 1:2021
Status : Amendment 1
Format : PDF

This malaysian Standard prescribes the rules for improving the safety of existing escalators and moving walks with the aim of reaching an equivalent lev ....Read more el of safety to that of a newly installed escalator and moving walk by the application of today’s state of the art for safety. NOTE. Due to situations such as the existing machine or building designs, it may not be possible in all cases to reach today’s state of the art for safety. Nevertheless, the objective is to improve the level of safety wherever possible.

This standard includes the improvement of safety of existing escalators and moving walks for:

a) users;
b) maintenance and inspection personnel;
c) persons outside the escalator or moving walk (but in its immediate vicinity); and d) authorised persons.

This standard is not applicable to:

a) safety during transport, installation, repairs and dismantling of escalators and moving walks;
b) spiral escalators; and
c) accelerating moving walks. However, this standard can usefully be taken as a reference basis. Close

FREE

Document will be sent via email



 Send To Email
Safety of escalators and moving walks – Part 1: Construction and installation (Second revision)
MS 1918-1:2019, AMD. 1:2021
Status : Amendment 1
Format : PDF

This malaysian Standard specifies the construction and installation of new escalators and moving walks (pallet or belt type) as defined in Clause 3. Thi ....Read more s standard deals with all significant hazards, hazardous situations and events relevant to escalators and moving walks when they are used as intended and under conditions of misuse which are reasonably foreseeable by the manufacturer (see Clause 4). This standard is not applicable to escalators and moving walks which were manufactured before the date of its publication. It is, however, recommended that existing installations be adapted to this standard. Close

FREE

Document will be sent via email



 Send To Email
Nitrile cleanroom gloves - Specification (ISO 23464:2020, IDT) (Published by Standards malaysia in 2022)
MS ISO 23464:2020
Status : Original
Format : PDF

This document specifies the specification for ISO Class 4, ISO Class 5 and ISO Class 6 nitrile cleanroom gloves. It is applicable to cleanroom gloves made of acrylonitrile butadiene material.

RM 15.00

Document will be sent via email



 Add To Cart
  • ‹
  • 1
  • 2
  • ...
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • ...
  • 523
  • 524
  • ›