• :  
BM ENG
  • Home
  • Service
  • International Standard
  • FAQ
  • Publish
  • signin
  •  Cart ()
Search Malaysian Standard (MS)
 Advanced Search Search




Masonry cement – Part 2: Test methods (Third revision)
MS EN 413-2:2021
Status : 3rd Revision
Format : PDF

This European Standard describes reference and alternative test methods to be used when testing masonry cements to assess their conformity to EN 413-1. It gives the tests on fresh mortar for consisten ....Read more ce, water retention and air content.

In the event of a dispute, only the reference methods are used. Close

RM 30.00

Document will be sent via email

For sale within Malaysia Only

 Add To Cart
Methods of testing cement – Part 1: Determination of strength (First revision)
MS EN 196-1:2021
Status : 1st Revision
Format : PDF

This part of EN 196 describes the method for the determination of the compressive and, optionally, the flexural strength of cement mortar. The method applies to common cements and to other cements and ....Read more materials, the standards for which call up this method. It may not apply to other cement types that have, for example, a very short initial setting time.

This method is used for assessing whether the compressive strength of cement is in conformity with its specification and for validation testing of a CEN Standard sand, EN 196-1, or alternative compaction equipment.

This part of EN 196 describes the reference equipment and procedure and allows alternative compaction equipment and procedures to be used provided that they have been validated in accordance with the appropiate provisions in this document. In the event of a dispute, only the reference equipment and procedure are used. Close

RM 60.00

Document will be sent via email

For sale within Malaysia Only

 Add To Cart
Storage, handling and transportation of liquefied petroleum gases (LPG) - Code of practice (Fourth revision)
MS 830:2021
Status : 4th Revision
Format : PDF

This Malaysian Standard specifies requirements for the location, design, construction, commissioning and operation of installations for the storage and handling of LPG.

RM 225.00

Document will be sent via email



 Add To Cart
LED modules for general lighting – Performance requirements (Second revision) (IEC 62717:2014+AMD1:2015+AMD2:2019,IDT)
MS IEC 62717:2021 (CONFIRMED:2024)
Status : 1st Confirmation
Format : PDF

This International Standard specifies the performance requirements for LED modules, together with the test methods and conditions, required to show compliance with this standard.

RM 90.00

Document will be sent via email



 Add To Cart
Lampholders for tubular fluorescent lamps and starterholders (Second revision) (IEC 60400:2017+AMD1:2020, IDT)
MS IEC 60400:2021
Status : 2nd Revision
Format : PDF

This document states the technical and dimensional requirements for lampholders for tubular fluorescent lamps and for starterholders, and the methods of test to be used in determining the safety and t ....Read more he fit of the lamps in the lampholders and the starters in the starterholders.

This document covers independent lampholders and lampholders for building-in, used with tubular fluorescent lamps provided with caps as listed in Annex A, and independent starterholders and starterholders for building-in, used with starters in accordance with IEC 60155, intended for use in AC circuits where the working voltage does not exceed 1 000 V r.m.s.

This document also covers lampholders for single-capped tubular fluorescent lamps
integrated in an outer shell and dome similar to Edison screw lampholders (e.g. for G23 and G24 capped lamps). Such lampholders are tested in accordance with the following clauses and subclauses of IEC 60238: 9.4; 9.5; 9.6; 10.3; 11.7; 12; 13.2; 13.5; 13.6; 13.7; 14; 16.3; 16.4; 16.5 and 16.9.

This document also covers lampholders which are integral with a luminaire or intended to be built into appliances. It covers the requirements for the lampholder only. For all other requirements, such as protection against electric shock in the area of the terminals, the requirements of the relevant appliance standard are applicable and tested after building into the appropriate equipment, when that equipment is tested according to its own standard. Lampholders for use by luminaire manufacturers only are not for retail sale.

This document also applies, as far as is reasonable, to lampholders and starterholders other than the types explicitly mentioned above and to lamp connectors. Where the term "holder" is used in this document, both lampholders and starterholders are intended. Where the term “bi-pin lampholder” is used, lampholders for wedged caps are also intended. Close

RM 165.00

Document will be sent via email



 Add To Cart
Fresh taro (corm) - Specification
MS 2712:2018
Status : Original
Format : PDF

This Malaysian Standard specifies the requirements for taro (corm) (Colocasia esculenta (L.) Schott) of the Araceae family to be supplied fresh to the consumer.
NOTE. Name of produce in referen ....Read more ce to MS 325. Close

RM 30.00

Document will be sent via email



 Add To Cart
Fresh soursop (Annona muricata L.) - Specification
MS 2704:2018
Status : Original
Format : PDF

This Malaysian Standard specifies the requirements for commercial varieties of soursop, (Annona muricata L.) of the family Annonaceae, to be supplied whole and fresh to consumers.
NOTE. Name of ....Read more produce is as described in MS 325. Close

RM 15.00

Document will be sent via email



 Add To Cart
Fresh mangosteen (Garcinia mangostana L.) - Specification
MS 2703:2018
Status : Original
Format : PDF

This Malaysian Standard specifies the requirements of commercial varieties for mangosteen (Garcinia mangostana L.) of the family Clusiaceae, to be supplied whole and fresh to consumers.

RM 15.00

Document will be sent via email



 Add To Cart
CODE OF PRACTICE FOR FIRE PRECAUTIONS IN THE DESIGN AND CONSTRUCTION OF BUILDINGS PART 5 : FIREFIGHTING STAIRWAYS AND LIFTS
MS 1183 : PART 5 : 1990
Status : Withdrawn
Format : PDF

This code of practice provides guidance for designers and the building construction team in providing firefighting stairways and lifts to assist the fire service in firefighting operations.

....Read more /> Some recommendations are also made with respect to passenger, goods and service lifts adjacent to a firefighting lift where they affect the use and safety of the firefighting lift. No recommendations are made for the use of any lift for the purpose of escape in the event of fire. Close

NOT FOR SALE

Please contact us if you are interested to purchase for reference.



Diesel fuel - Specification - Part 3: Euro 5 (First revision)
MS 123-3:2019
Status : 1st Revision
Format : PDF

This Malaysian Standard specifies the requirements for diesel fuel (Euro 5) suitable for use in automotive, industrial and other diesel applications.

RM 15.00

Document will be sent via email



 Add To Cart
  • ‹
  • 1
  • 2
  • ...
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • ...
  • 580
  • 581
  • ›
©2020 All rights reserved
Department of Standards Malaysia (STANDARDS MALAYSIA). Best viewed on latest browser.