THERMAL INSULATING PRODUCTS FOR BUILDING APPLICATIONS - DETERMINATION OF WATER VAPOUR TRANSMISSION PROPERTIES
This Malaysian Standard specifies the equipment and procedures for determining the water vapour transmission rate, water vapour permeance and water vapour permeability of test specimens in the steady state under different sets of specified test conditions. It is applicable to thermal insulating products. It is intended to be used for homogeneous materials (see note 1) and for products which may contain integral skins or facings of different material(s). NOTE I A material is considered to be homogeneous, with regard to mass distribution, if its density is approximately the same throughout, i.e. if the measured density values are close to its mean density. NOTE 2 This test method is not normally used for determining the water vapour transmission properties of single, separate vapour harriers (of high diffusion resistance ), such as prefabricated films, foils, membranes or sheets, due to the long duration of the test. For products with a vapour retarder or barrier with a water vapour diff
Published
• (none) / (none) / (none)
PDF
24/04/2019
18
NSC 04 - Construction, Building, and Civil Engineering
