PLASTICS - INJECTION MOULDING OF TEST
SPECIMENS OF THERMOPLASTIC
MATERIALS -
PART 2 : SMALL TENSILE BARS
(ISO 294-2:1996, IDT)
This Malaysian Standard was developed by the Technical Committee on General Methods of
Test for Plastics under the authority of the Plastics and Plastics Products Industry Standards
Committee.
This Malaysian Standard is identical with ISO 294-2:1996, Plastics — Injection moulding of test
specimens of thermoplastic materials — Part 2: Small tensile bars, published by the
International Organization for Standardization (ISO), which has the same title. The text of the
International Standard is recommended for publication as a Malaysian Standard without
deviation. However, for the purposes of this Malaysian Standard, the following apply:
a) in the source text, “this International Standard” should read “this Malaysian Standard”;
and
b) the comma which is used as a decimal sign (if any), to read as a full point.
c) references to International Standards should be replaced by equivalent Malaysian
Standards.
