PLASTICS - DETERMINATION OF TENSILE PROPERTIES - PART 4: TEST CONDITIONS FOR ISOTROPIC AND ORTHOTROPIC FIBRE-REINFORCED PLASTIC COMPOSITES (ISO 527-4:1997, IDT)
This Malaysian Standard was developed by the Technical Committee on General Methods of
Test for Plastics under the authority of the Plastics and Plastics Products Industry Standards
Committee.
This Malaysian Standard is identical with ISO 527-4 : 1997, ‘Plastics – Determination of
tensile properties – Part 4 : Test conditions for isotropic and orthotropic fibre-reinforced plastic
composites’, published by the International Organization for Standardization (ISO), which has
the same title. The text of the International Standard is recommended for publication as a
Malaysian Standard without deviation. However, for the purpose of this Malaysian Standard,
the following apply:
a) in the source text, “this International Standard” should read “this Malaysian Standard”;
and
b) the comma which is used as a decimal sign (if any), to read as a full point.
References to International Standards should be replaced by equivalent Malaysian Standards
as follows:
Referenced International Standard Corresponding Malaysian Standard
ISO 527-1 : 1993, Plastics –
Determination of tensile properties – Part
1 : General principles
MS ISO 527-1 : 1994, Plastics –
Determination of tensile properties – Part 1 :
General principles
ISO 527-2 : 1993, Plastics –
Determination of tensile properties – Part
2 : Test conditions for moulding and
extrusion plastics.
MS ISO 527-2 : 1994, Plastics –
Determination of tensile properties – Part 2 :
Test conditions for moulding and extrusion
plastics.
ISO 527-5 : 1997, Plastics –
Determination of tensile properties – Part
5 : Test conditions for undirectional fibrereinforced plastic composites.
MS ISO 527-5 : 2001, Plastics –
Determination of tensile properties – Part 5 :
Test conditions for undirectional fibrereinforced plastic composites.
ISO 2818 : 1994, Plastics – Preparation of
test specimens by machining.
MS ISO 2818 : 1995, Plastics – Preparation
of test specimens by machining.
Compliance with a Malaysian Standard does not of itself confer immunity from legal
obligations.
NOTE. IDT on the front cover indicates an identical standard i.e. a standard where the technical content, structure,
wording and presentation of a Malaysian Standard is exactly the same as in an International Standard or is identical
in technical content and it may contain the minimal editorial changes specified in clause 4.2 of ISO/IEC Guide 21
