Low temperature, low shear rate, viscosity/
temperature dependence of lubricating oils
using a temperature-scanning technique -
Test method
(First revision)
1.1 This test method covers the measurement of the apparent
viscosity of engine oil at low temperatures.
1.2 A shear rate of approximately 0.2 s-1 is produced at
shear stresses below 100 Pa. Apparent viscosity is measured
continuously as the sample is cooled at a rate of 1 °C ⁄h over
the range −5 °C to −40 °C, or to the temperature at which the
viscosity exceeds 40 000 mPa·s (cP).
1.3 The measurements resulting from this test method are
viscosity, the maximum rate of viscosity increase (Gelation
Index), and the temperature at which the Gelation Index
occurs.
1.4 Applicability to petroleum products other than engine
oils has not been determined in preparing this test method.
1.5 The values stated in SI units are to be regarded as
standard. No other units of measurement are included in this
standard.
1.6 This standard does not purport to address all of the
safety concerns, if any, associated with its use. It is the
responsibility of the user of this standard to establish appropriate
safety and health practices and determine the applicability
of regulatory limitations prior to use.
