PLASTICS PIPING SYSTEMS FOR HOT AND COLD WATER INSTALLATIONS – POLYBUTYLENE (PB) PART 2 : PIPES (ISO 15876-2:2003, MOD)
This Malaysian Standard specifies the characteristics of pipes made of polybutylene (PB) for piping systems intended to be used for hot and cold water installations within buildings for the conveyance of water whether or not intended for human consumption (domestic systems), and for heating systems, under design pressures and temperatures appropriate to the class of application.
This standard covers a range of service conditions (application classes), design pressures and pipe dimensionclasses. For values of TD, Tmax and Tmal in excess of those in Table 1 of Part 1, this standard does not apply.
NOTE 1It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes.
It also specifies the test parameters for the test methods referred to in this standard.
In conjunction with the other Parts of EN ISO 15876 (see F
