PLASTICS - DETERMINATION OF TENSILE PROPERTIES : PART 2: TEST CONDITIONS FOR MOULDING AND EXTRUSION PLASTICS (ISO 527-2:1993, IDT)
This Malaysian Standard was prepared by the Working Group on Mechanical Properties
under the PA 3 Project Area on General Method of Tests for Plastics. The Working Group
was formed under the authority of the Plastics Industry Standards Committee.
This Malaysian Standard is identical with ISO 527-2 : 1993 ‘Plastics – Determination of tensile
properties – Part 2 : Test conditions for moulding and extrusion’, published by the
International Organization for Standardization (ISO).
For nomative references specified in clause 2, the following are equivalent malaysian
Standards.
International Standards Corresponding Malaysian Standards
ISO 37 : 1977 MS 1157 : Part 3 : 1993
ISO 293 : 1986 MS 1336 : 1993
ISO 294 MS 1335 : 1993
ISO 2818 MS 1338 : 1993
Therefore, for the purpose of this standard, these Malaysian Standards shall be referred to.
Users should note that all International Standards undergo revision from time to time and that
any reference made herein to any other international Standard implies its latest edition,
unless otherwise stated.
