• :  
BM ENG
  • Home
  • Service
  • International Standard
  • FAQ
  • Publish
  • Sign In
  •  Cart ()

MS Preview

MS ISO 15876-3 : 2004
PLASTICS PIPING SYSTEMS FOR HOT AND COLD WATER INSTALLATIONS – POLYBUTYLENE (PB) PART 3: FITTINGS (ISO 15876-3:2003, MOD)
This Malaysian Standards specifies the characteristics of fittings for polybutylene (PB) piping systems intendedto be used for hot and cold water installations within buildings for the conveyance of water, whether or not intendedfor human consumption (domestic systems) and for heating systems under design pressures and temperaturesaccording to the class of application (see Table 1 of EN ISO 15876-1:2003). This standard covers a range of service conditions (application classes) and design pressure classes. For values of TD, Tmax and Tmal in excess of those in Table 1 of Part 1, this standard does not apply. NOTE It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes. It also specifies the parameters for the test methods referred to in this standard. In conjunction with the other parts of EN ISO 15876 (
Published
• (none)  / (none)  / (none)

PDF

12/04/2019
25
NSC 10 - Plastics and Plastic Products
83.140.3091.140.60
30.00

 Add To Cart
©2020 All rights reserved
Department of Standards Malaysia (STANDARDS MALAYSIA). Best viewed on latest browser.