Cold-reduced carbon steel sheet and strip of commercial and drawing qualities
(First revision)
1.1 This Malaysian Standard applies to cold-reduced carbon steel sheet and strip of commercial and drawing qualities. It is suitable for applications where the surface is of prime importance.
1.2 Commercial quality sheet and strip (SPCC) is intended for general fabricating purposes where sheet is used in the flat condition or for bending, moderate forming and welding operations.
1.3 Drawing quality sheet and strip (SPCD, SPCE, SPCF, SPCG) is intended for drawing or severe forming, including welding. Drawing quality sheet is furnished according to all the requirements of this Malaysian Standard, or, by agreement when ordered, to fabricate an identified part, in which case, the mechanical property requirements do not apply. Drawing qualities are identified as follows:
a) SPCD - Drawing quality;
b) SPCE - Deep drawing quality;
c) SPCF - Deep drawing quality aluminum killed (non-ageing); and
d) SPCG - Extra deep drawing quality (stabilised interstitial free).
1.4 Interstitial free steel (IF steel) can be applied on orders of SPCD, SPCE and SPCF, provided that the customer is informed of the substitution and related shipping documents reflect the actual material shipped.
1.5 Cold-reduced sheet less than 600 mm wide can be slit from wide sheet and will be considered as sheet.
